When taking to the installation of the fence, it is worth taking a moment to stop over the installation of the poles. Surely everyone would like the mounted structure to be stable and durable. It is also important to do it neatly with the least effort.

In our shop you will find elements that will allow you to assemble the stubbornness without unnecessary welding. This is a very simple technique, which is characterized by great strength. This set consists of a cap, clamp and screw (see below). The clamp is located on a vertical column, the cap closes the oblique column and with a screw these elements are connected.

When moving smoothly to the very assembly of the resistance, it should be remembered that the start and end columns stabilize with the help of a reinforcement support.

The corner post is mounted at those points of the fence, where it changes its direction and has two resistances, which additionally keep the structure vertical. The supports are mounted at a height of 2/3 of the vertical column. They are set at an angle of 45° which guarantees protection against overturning of the fence.

It is worth noting that if any side of the fence is longer than 45 m, it is recommended to divide it into smaller sections. For this purpose, also, peror poles are used, which strengthen the structure.

For greater protection, all evaporator poles should be concreted in the ground. As a rule, about 60cm of pole length is used for this.